Each product has its own list of compatible video, audio and image formats. The best way to know what file type is specifically supported by your product is to look in the user guide for your particular model.
Open the projector Menu and go to System Setting: Basic> Projector Position and choose one of the four available options: Front Table Rear Table Ceiling Front Ceiling
Please refer to user guide on page "Important Safety Instructions". Some projectors may be claimed to use at a limited angle dependent on the light source, such as lamp or LED.
Make sure that you have set it to its native resolution. Check the user guide to determine what the native resolution of the display is and set it to the native resolution if the video source that is being used can support it. Digital signals (HDMI, DisplayPort) normally produce sharper images. If you are using a VGA or analog signal try to s...
Please follow below steps: Connect your device and projector to the same Wi-Fi network. 2. On projector, go to Home > Screen Mirroring, there is projector's device name shown at the upper right location. (e.g. "ViewSonic PJ-XXXX") 3.On your phone/tablet, do the following: iOS: Access...
Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...
Verify adapter plugged into a wall outlet Make sure the AC adapter is firmly and securely plugged into the wall outlet. Although it may sound obvious, the adapter can become loose without even knowing. If it's not plugged in all the way, it can make it seem like the adapter is not working, but it may just not be getting power from the wall...
1. Press the menu button on the projector or the remote control and then navigate to the Advanced Settings. 2. Select to restore factory default settings. Note: Some models may have the reset option in a slightly different location. Please check the user guide for specific steps.
If a fan begins to make a rumbling noise this may indicate a problem with the fan. Fans are essential to maintain optimal operating efficiency of the projector; so it is strongly recommended that the unit be sent in for service to replace the fan. If it seems like there is something hitting the fan blades it could mean that there is an obstru...
Before connecting two projectors to your Windows PC/laptop, please ensure your system can run multiple video outputs. 1. To check your graphics card's maximum number of output signals, please refer to the graphics card manufacturer like the example below. Dedicate Graphics Card Integrate Graphics Card 2. Make sure your devi...