The monitor’s OSD pivot function is only effective for the OSD window itself. Additionally, the vDisplay Manager software will be required for the operating system to automatically adjust the monitor’s orientation.
For optimal performance, please make sure your monitor is fully up to date. If your VP2468 monitor’s firmware version is M001 or M002, please make sure your OSD Pivot and Auto-Pivot functions are, both, set to Auto.
The Auto-Pivot function uses DDC/CI to communicate with the monitor. Please make sure not to turn off the monitor’s DDC/CI option in the OSD menu when you are using the Auto Pivot function.
The input source auto detect function is only supported by specific model of monitors. Please refer to the user guide to confirm this feature. If your monitor supports this feature, it will be disabled by default. Please make sure to enable it within the OSD menu.
Since OSD pivot function in the OSD menu only affects the OSD menu itself. Please also install vDisplay Manager in your operating system so that your operating system screen can automatically rotate with the monitor’s orientation.
As of Dec. 8 2020, below VP models support Auto Pivot function. VP2458, VP2468, VP2468a, VP2768, VP2768a, VP2785-4K VP2768-4K, VP2785-2K, VP2771, VP2775, VP3268-4K. Please refer to below steps to enable the function. 1.Download and install vDisplay Manager. 2.Follow UG for connection and setting. 3.Enable DDC/CI in monitor OSD to...
Please make sure to connect PC to the DisplayPort input instead of the DisplayPort output port on the monitor. If your graphic card is capable of DisplayPort 1.1, please follow these steps and adjust monitor setting: “Menu >> Setup Menu >> DisplayPort 1.2 Off”.
Please make sure to use “FW_Update_Tool_v1.08”. Please follow the step by step instructions below to resolve the problem. When the program is initialized, the error message shown below will appear. A Windows error message might also pop up few seconds later. Please close the program and the error messages, then follow the in...
There are 2 ways: 1.On Monitor, please navigate to OSD -> Setup Menu -> Information, where you will see your current firmware version. **For VP2468 versions M001 and M002, this function is not supported. If the firmware version is not present in the Information page, please update to version M010 or later. 2. On PC/Laptop, you ...
You can set the Orientation setting to Landscape/CW90°/CCW90° or disable the “Auto Pivot” application.