The recommended tools (unless otherwise stated) needed to install a dvLED Display is as shown below:

• Self-leveling laser level
• Stud sensor/finder - multi-depth/material
• (2) 8’ ladder
• Anti-static gloves (required)
• 3/8” hammer drill/driver
• ¼” impact driver
• Pilot point drill bit set for metal
• Metric ball-end hex key set
• Impact-ready bit set – Phillips and slotted #2 and #3
• Impact-ready nut driver set ¼” to ½”
• 4-vial torpedo levels – 12” and 2’ length
• Steel step drill bit
• Toggler drywall anchors – 3/16” diameter
• Tapcon concrete anchors – ¼” drive x 1 ¾” or longer pending wall substrate
• Steel lag screw – 5/16th drive x 1 ¾” or longer pending wall substrate
• Shop vacuum
• Moving blankets/pop-up work tables
• Convertible hand truck/dolly
• Pen/pencil/Sharpie
• 25’ steel magnetic tape measure