Answer: You can set the entry screen after the display is turned on. From the main menu go to Display settings then Startup & Shutdown. Choose whether to continue the input source from last shutdown, or to specify a specific source (Home, HDMI, myViewBoard Display, or vCast).
Answer: The entire LED display is made up of many LED modules. LED Modules will be in units of four. These four units will be controlled by the same set of “Transfer Board,” “Receiving Card,” and “Power Board for LED Module.” (one per four LED modules) Recommended Links "How many Receiving Cards and Transfer Boards are there on a dvLE...
Answer: The Transfer Board (aka Transfer Card) plays a part in supplementing LED Module signal connection. It is directly connected to the LED Modules and mounted onto a Cabinet as shown in Diagram 1 below. Diagram 1: Transfer Card mounted onto a Cabinet The Transfer Board houses the Receiving Card. The Receiving Card does not need to b...
Solution Step 1: Obtain the Vacuum Suction Tool Step 2: Remove the target LED module. Note that the whole display will have the same batch number, so it may not matter which LED module you remove. Step 3: Refer to the following location for the batch number on the underside of the LED module: Step 4: The 12-character alphanumeri...
Answer: LED modules should be placed on a flat, anti-static, padded surface when swapping LED Modules. If there is no opening for the connectors, module should be placed bead-side down to prevent connector damage. Product Safety The following components on the LED module can be damaged if not handled well: LED Bead damage diagram ...
LED Modules (either damaged and/or undamaged) should be stored in module boxes according to the following packaging steps when not mounted on the display. If there is a shortage of module boxes, please contact Customer Service. Please refer to the Proper LED Module Packaging SOP for full details. Solution Obtain the Module Box(s). Eac...
Before LED Modules are shipped out, they must be packaged in a specialty Module Box according to the following packaging steps specifically designed to hold LED modules. Please refer to the Proper LED Module Packaging SOP for full details. Solution Obtain the Module Box(s). Each module box should be able to hold 4 LED modules. NOTE: ...
Answer: Yes. The remote controls that operate a ViewSonic projector will also work on a DVLED Display.
The number of Receiving Cards and Transfer Boards will vary by model. However, Since a 1x Receiving Card is required to connect with 1x Transfer Card, the number of Receiving Cards will be consistent with the number of Transfer Boards. Solution Complete information can be found in the "LED Display Product Engineering Specification" docu...
After replacement of a particular LED module, brightness may be slightly different than that of other modules. At this point, manual calibration is required. In order to troubleshoot this problem, the following procedure can be followed: Solution Step 1: Use the USB B-to-A cable to connect the display to the computer. Step 2: A...