How to solve flickering image on projector?

  Make sure the signal cable is securely connected.           2.Try another video input source or cable or device to crosscheck.           3.Check the current resolution and refresh rate set in the graphic card or video source is            compatible with the projector. You can refer to refresh rate setting video.           How t...

How to change the projector lamp in a projector?

The methods for changing the projector lamp (bulb) differ depending on the model of the projector. For accurate instructions, you can find lamp swapping instruction at ViewSonic product download page.   <Note> It is recommended that you use an authentic ViewSonic replacement lamp.  

There is a pixel stuck on or off

Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...

How to restore the default settings on a projector?

1. Press the menu button on the projector or the remote control and then navigate to the Advanced Settings.   2. Select to restore factory default settings.   Note: Some models may have the reset option in a slightly different location. Please check the user guide for specific steps.

What devices support USB Type C video streaming on M1, M1+, M2 and X10-4K?

The USB Type-C port on your device must support DP Alt mode (DisplayPort Alternative Mode on USB-C). USB Type-C refers to the connector type, not the capability of the port itself, and please note that not all USB Type-C ports support video output (Video over USB Type-C). USB Type-C ports with any of the following symbols nearby will be...

What's the duration of Security Update Support for ViewSonic Consumer Projectors?

ViewSonic will offer security update support to the below consumer projector products in compliance with the UK’s Consumer Connectable Product Security Regime until the dates specified below. Product End of Support LS741HD/   VS19894/ CPD60HD/ HC60HD/ T60HD/ KL60HD/ V60HD/ LS741HDE/ LS741HDP/ LS741HDC/   LS751HD/ VS19337/ CPD42HD/ ...

Why am I unable to do wireless casting from my laptop via PJ-WPD-700?

For wireless casting via PJ-WPD-700, it's necessary to connect to an USB-C port of laptop/desktop which supports DP Alt mode (DisplayPort Alternative Mode on USB-C). USB Type C refers to the connector type, but not the capability of the port itself. Also, not all USB Type C ports support video output (Video over USB Type C). USB-C ports...

How to wirelessly mirror mobile phone/tablet screen to a smart projector?

Please follow below steps:   Connect your device and projector to the same Wi-Fi network.           2. On projector, go to Home > Screen Mirroring, there is projector's device name shown at the upper right               location. (e.g. "ViewSonic PJ-XXXX")          3.On your phone/tablet, do the following:   iOS: Access...

How to calibrate Auto Focus on M2e if the auto focus is not clear ?

The perception of clarity can differ from person to person if the result of auto-focusing is not up to the level of clarity that you wish it to achieve you could also try out manual focusing by following the instruction below: 1. Focus sensor design behavior        Focus sensor in M2e is designed to trigger manual focus control center...

Why is Netflix freezing after updating?

If Netflix is freezing after updating the application, please follow the steps below: Please make sure your Netflix application is downloaded from the ViewSonic application store. If a message appears in the Netflix application asking you to update, please press Cancel. If you have updated the Netflix application, please uninstall...