Please go to Projector Distance Calculator. Enter the desired distance from the screen to calculate the image dimensions. Try different distance values until you find the desired image size.
Verify adapter plugged into a wall outlet Make sure the AC adapter is firmly and securely plugged into the wall outlet. Although it may sound obvious, the adapter can become loose without even knowing. If it's not plugged in all the way, it can make it seem like the adapter is not working, but it may just not be getting power from the wall...
1. Here are the hardware requirements to play 3D content below. a. 3D ready projector b. 3D Blu-Ray player c. 3D content d. Active 3D glasses 144Hz e. HDMI Premium Certificate cable 2. Here is the playback process below. a. Connect the 3D Blu-Ray player to the 3D capable projector via HDMI cable. b. T...
Parts can be purchased from our parts store. Go to https://www.viewsonic.com/parts/
Please check below: 1.Plesae refer to the user guide and adjust Aspect ratio with example below. 2. It could be the format of the movie since not all movies are formatted in 16:9. Some are formatted wider than 16:9 which will create black borders on the top and bottom of the screen.
Make sure the signal cable is securely connected. 2.Try another video input source or cable or device to crosscheck. 3.Check the current resolution and refresh rate set in the graphic card or video source is compatible with the projector. You can refer to refresh rate setting video. How t...
When you see below situation, please follow below instructions to adjust: If the projector supports Auto Keystone or Vertical keystone, please try to turn on or manually adjust by referring to user guide. If possible, put the projector on the flat surface and make sure projector lens and screen are in a 90-degree angle.
The methods for changing the projector lamp (bulb) differ depending on the model of the projector. For accurate instructions, you can find lamp swapping instruction at ViewSonic product download page. <Note> It is recommended that you use an authentic ViewSonic replacement lamp.
Please refer to user guide on page "Important Safety Instructions". Some projectors may be claimed to use at a limited angle dependent on the light source, such as lamp or LED.
Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...